Viewing Photos, Playing Music And Watching Videos On A Usb Memory Stick; Install Channels; Autoprogram - Magnavox 55MV314X Owner's Manual

Viewing Photos, Playing Music and
Watching Videos on a USB Memory Stick
Your TV is fitted with a USB connection that enables you to
view photos, listen to music or watch video files stored on a
USB Memory Stick.
1
Display Setup using Home Menu and use H I to Select
USB, then press OK.
2
Use H I to select Start now, then press OK.
3
Use H I to select the Picture, Music or Video, then
press OK.
avi
Picture
jpg
mp3
Music
Image1.jpg
Image2.jpg
Video
Image3.jpg
Image4.jpg
Image5.jpg
These Recorded Files must meet Specifications shown below:
●
Picture (JPEG)
Upper limit
Music (MP3)
Sampling frequency
Constant bit rate
Video (MPEG / VOB / AVI / MP4)
Maximum
Video
Extension
.mpg, .mpeg
Video codec
MPEG1,
MPEG2
Audio codec
Dolby Digital
YES
MPEG1 audio
YES
layer3 (MP3)
MPEG1 audio
YES
layer2
LPCM
YES
AAC-LC
NO
Note(s)
O
This unit accepts USB Memory Stick only. Other storage devices
●
such as external HDD by USB Bus Power will not work.
Do not use an extension cord and USB Hub to connect devices
●
to this Unit. Always insert the USB flash memory in to this Unit
directly.
We cannot be held responsible if your USB Memory Stick is Not
●
Supported, nor will we accept any liability for damage or loss of
stored data.
The USB Memory Stick is Not Supplied with this TV.
●
A maximum of 1,023 folders or files can be recognized.
●
A file name exceeding 256 characters or contains a dot character
●
is Not Supported on this TV.
Progressive JPEG files are Not Supported.
●
16Mpixel
32 kHz, 44.1 kHz or 48 kHz
32 kbps - 320 kbps
1920 x 1080
.vob .avi
MPEG4 SP,
MPEG2
MPEG4 ASP
YES YES
NO YES
NO YES
NO NO
NO NO

5 Install Channels

Autoprogram

Be sure the RF cable is correctly connected to this Unit and
you are registered with your Cable TV provider when you
Install Cable channels.
1
Display Setup using Home Menu and use H I to Select
Installation, then press OK.
2
Use H I to Select Channels, then press OK.
3
Use H I to Select Autoprogram, then press OK.
4
Press OK to Select Start now.
Autoprogram will start automatically.
●
System searching. Please wait...
Digital channels found:
Analog channels found:
Auto programming may take more than 20 minutes to
complete.
If you run Autoprogram when you have Locked Channels, a
●
Message appears asking to enter your PIN. Enter your PIN in
order to Complete the Installation. You need to set the
Channel Lock again after the Installation.
When the Scanning and Memorizing of Available Channels is
●
Completed, the Lowest Memorized Channel will be
.mp4
Displayed.
5
H.264,
Follow the On-screen Instructions to Complete the
MPEG4
Installation.
NO
NO
NO
NO
YES
14
0
0
Stop