Inserting And Removing Sd Cards - National Instruments 2 SD Card Memory Module NI 9802 Operating Instructions Manual

2 sd card memory module operating instructions and specifications

Table of Contents

the system in a metal enclosure. Suppression ferrites

must be installed on power supply inputs near power

entries to modules and controllers. Power supply and

module cables must be separated on opposite sides of the

enclosure and enter/exit through opposing enclosure

walls.

Inserting and Removing SD Cards

The NI 9802 has two SD Card slots into which you can insert

NI-approved SD Cards.

Note

invalidate specifications and result in unreliable

performance.

The card slots each have a door to protect the SD Cards while in

the module. Each door is connected to a switch that indicates to the

NI 9802 software when it is safe to read from or write to the

SD Card.

The NI 9802 has four LEDs that indicate which slots contain an

SD Card and if the SD Card is active. Refer to Figure 1 for the

designation of SD Card slots and LEDs. Refer to Table 1 for

Using SD Cards that are not approved by NI might

NI 9802 Operating Instructions and Specifications

Table of Contents

Do you have a question about the 2 SD Card Memory Module NI 9802 and is the answer not in the manual?

Ni 9802