Philips HTS8100 Service Manual page 21

Dismantling Instructions & Service Positions
4.1.3 Dismantling of Door Board, Motor Assembly, DVD
Mechanism, and Front Board
1) Remove the Rear Cover fi rst (fi gure 1), remove the HDMI
assembly (1060 + 134, fi gure 4), remove the SD9.2 Mono
Board 1070 (fi gure 5), if it is necessary, and then remove
the Rear Frame assembly (132+1040+135+1020 for
/05/12, and 132+1030+135+1020 for /37/59) by removing
13 screws as shown in fi gure 8.
Figure 4-8
1) Remove 4 screws to dismantle the Door Board, Motor
and Gear Box Assembly (115+116+117+118+119+1090
+1014). Remove1 screw to detach the Door Board 1014
from the Motor and Gear Box Assembly (115+116+117+1
18+119+1090). The mounting screws are shown in fi gure
9.
I-2
Figure 4-9
H
I-1
3139 785 32540
3) Remove 4 screws to dismount the DVD assembly (127+
129 +1080) as shown in fi gure 10. Flip over the assembly
to see the 4 screws that attach the DVD Mechanism
1080 to the Traverse Bracket 127 as shown in fi gure 11.
Remove the screws and detach the DVD Mechanism
from the Assembly (Refer to "Service Hints" in chapter 2
for replacing the DVD mechanism.)
J
Figure 4-10
K
Figure 4-11
4) Remove 3 screws to dismount the Front Board as shown
in fi gure 12.
L
Figure 4-12
4. EN 21