Makita BFL300F Technical Information page 13

W
iring diagram
[3] Wiring the Lead Wires from LED Circuit on Lead Holder
Fig. 31
Make the lead wires so that
they cannot be pulled to
disconnect LED circuit from
Controller when Switch
cover is installed.
Hook the lead wires
on the five tabs of
Lead holder.
Remark:
Do not place the lead
wires over the tabs.
Route the lead wires
under the pin.
Route the lead wires
beside rib (K) and
Switch unit (for Clutch).
Switch unit (for Clutch)
tab
tab
pin
rib (K)
LED circuit
tab
Route the lead wires between
rib (H) and rib (I), and then
rib (I) and rib (J).
rib (H)
rib (I)
rib (J)
Put Connector and the sag
of the lead wires in the space
between Housing and rib (L).
rib (L)
Connector
P 13/ 13