Makita BFL300F Technical Information page 12

W
iring diagram
[2] Wiring Around Stator
Fig. 30
Place Connectors and the sag
of lead wires in the space
between rib (E) and the inside
wall of Housing.
inside wall of Housing
Route the following lead wires from Controller
between rib (E) and the inside wall of Housing;
*wires to LED circuit
*wires to switch unit (for Clutch)
At this time, place the lead wires so that the tape
is positioned beside Printed wiring board.
Route the three lead wires
(orange, white, blue) from
Controller to Stator between
the pin and Stator.
First, put the following lead wires from Controller
in place;
*wires to LED circuit
*wires to switch unit (for Clutch)
Then, with the lead wire holder, fix the lead
wires (orange, white, blue) from Controller to
Stator.
Connector (to LED circuit)
tape
lead wire holder
Switch unit (for Clutch)
Connector
rib (E)
Printed wiring board
pin
Stator
rib (F) rib (G)
Route the six lead wires (orange, black, white,
yellow, blue, red) from Controller to Stator
between rib (F) and rib (G).
P 12/ 13