Makita BFL300F Technical Information page 11

W
iring diagram
[1] Wiring Around Controller
Fig. 29
rib (A)
Route the lead wires from
Switch unit (for rotation
reverse) between rib (A)
and rib (C).
rib (B)
Route the lead wires from
Switch unit (for Trigger)
between rib (B) and rib (C).
rib (C)
Put the lead wires from
Controller to Buzzer on
the groove in Controller.
groove
Install Receptacles on
Terminal as illustrated
to right.
Switch
Controller
Buzzer
circuit
Lead wire (black)
Lead wire (red)
Route the lead wires (orange,
white, blue) from Controller
to Stator between the two pins.
pin
Place Connectors and the sag
of lead wires in the space
between ribs (A)- (B)- (C)
and pins- rib (D)- boss.
rib (D)
Connector
boss
Put Connector and the lead
wires from Controller to
Buzzer between the ribs
on Controller.
Connector
rib
Terminal
Receptacles
Terminal
P 11/ 13