Advertisement
4
General information
Nominal heat
output
max speed
27,300 BTU/hr
.25 US gal/hr
8 kW
0.96 liter/h
Care of enamelled parts
Do not use abrasive cleaners to clean these parts. Buff lightly with a clean, dry cloth. Porcelain enamel components must
be handled with care. The baked-on finish is "glasslike". If struck, it will chip. Touch-up paint is available through your
Napoleon dealer.
Care of glass
If the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot burn will clean the
glass. The most common reason for dirty glass is running the unit at a low burning rate. If it is necessary to clean the glass,
use a soft cloth with a nonabrasive cleaner. Coarse cleaning materials may cause scratches or otherwise damage the
glass. Scratches can develop into cracks or breaking of the glass.
The glass is very strong for maximum performance. However, always close the door gently. If the glass should ever crack
while the fire is burning, do not open the door until the fire is out and do not operate the stove again until the glass has
been replaced with new borosilicate glass, available from your Napoleon / Wolf Steel Ltd. dealer. DO NOT SUBSTITUTE
MATERIALS. Check gaskets and seals regularly.
INSTALLATION
WARNING : Improper installation, adjustment, alteration, service or maintenance can cause injury or property
damage. Refer to this manual. For assistance or additional information consult a qualified installer, service agency
H
or the oil supplier.
Unit and specifications
5 3 5 ( 2 1 " )
Document n° 1043-1 ~ 15/01/2002
Oil consumption **
min speed
.073 US gal/hr
0,28 liter/h
DO NOT CLEAN GLASS WHEN HOT !
1 4 5
( 5 3 / 4 " )
Chimney draft required
max speed
min speed
.06" w.c.
.024" w.c.
15 Pa
6 Pa
5 0 5 ( 2 0 " )
Ø
1 2 5 ( 5 " ) i n t .
5 5 2 , 5 ( 2 1 3 / 4 " )
Figure 1
Flue outlet inside
Weight
diameter
220 lbs
5 inches
100 kg
125 mm
Ø
1 2 5 ( 5 " ) i n t .
Ø
1 0 0
( 4 " ) e x t .
Advertisement
