Napoleon BGDV42N Installation And Operation Instructions Manual page 19

GDL42 LOUVRE INSTALLATION
UPPER LOUVRE
SLOT
a
DOOR LATCH
FIGURES 37
HINGE SCREEN
b
LOWER LOUVRES
(VALVE CONTROL DOOR)
L42 LOUVRE INSTALLATION
FIGURE 38
A
B
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
S L O T
right corners of the unit.
TA B
A
B
LOWER LOUVRES
HINGE
Insert the hinge clips into the
S L O T
CLIP
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
FINISHING
TO INSTALL THE UPPER
LOUVRES: Insert the upper
louvres into the slots on
both brackets.
TO INSTALL THE LOWER
LOUVRE ASSEMBLY: At-
tach each hinge to the fire-
box with 2 screws.
Position the hinge screen
into place and with the con-
trol door open, secure to the
firebox using three screws.
LOGO PLACEMENT
Remove the
backing of the
logo supplied and
place on the glass
viewing door, as
indicated.
PORCELAIN REFLECTIVE PANELS
1. Remove the upper louvres, and open the glass door.
Remove the logs.
2. Remove the securing screw al-
ready in place at the back of the fire-
box. If the unit is supplied with a rear
log support, remove before install-
ing the rear panel. Place the rear
panel against the back of the firebox
and re-install the rear log support over the panel, if sup-
plied. Secure using the original screw.
3. Remove the two securing screws located on either fire-
box side.
4. Place the left panel against the
left side of the firebox, ensuring
that it butts up to the rear panel.
Secure in place using 2 of the
screws previously removed. Re-
peat for the right side.
5. Replace the logs, glass door
and louvres.
½"
½"
FIGURE 39
W415-0381 / C / 05.13.04
19