Napoleon BGD48N Installation And Operation Instructions Manual page 19

Natural and propan gas fireplaces
Table of Contents

Advertisement

NAILING TAB INSTALLATION
1) Attach the nailing tabs to the corner posts using the 2
sheet metal screws supplied. Secure through the
centre of the top and bottom slots in the nailing
tab and then through the existing holes in the
corner posts.
If there are no existing holes, follow these
instructions:
Position the nailing tab so that the front face
is offset with the front edge of the corner post
(approx. ½"). Centre the nailing tab vertically
on the corner post.
Figure 40 a.
Drill through the centre of the top and bottom
slots in the nailing tab. Secure using the two
sheet metal screws supplied. This allows the
nailing tab to slide back and forth for desired
framing. Figure 40 b.
2) To determine the fi nal location of the nailing tab
you must fi rst determine the thickness of your fi nishing
material (i.e. drywall). This will determine the dimension from
the front edge of the corner post to the nailing tab. Once the nailing
tab is in the desired location, drill through the centre hole of the nailing
tab. Secure with a sheet metal screw*. Figure 40 c.
* Additional set screws may be installed.
CORNER
POST
NAILING
TAB
TOP SLOT
A
B
FINISHING
MATERIAL
CENTRE
HOLE
C
LOG PLACEMENT / GLOWING EMBERS
PHAZER
FIGURE 39
places, provide a unique and realistic glowing effect that is different
in every installation. Take the time to carefully position the glowing
embers for a maximum glowing effect. Log colours may vary. During
the initial use of the fi replace, the colours will become more uniform as
colour pigments burn in during the heat activated curing process.
NAILING
TAB
FIGURES 41a-h
1. Center the rear log (#1) behind the rear burner and onto the log
support.
FIGURES 40a-c
2. Place log#2 and log#3 onto the locating pins. The logs should sit
fl at on the burner.
3. Place the locating hole on the underside of log#4 onto the locating
pin on top of log#3. The notch at the opposite end of log#4 sits on
the third grate post in from the right.
FINISHING
TM
logs and glowing embers, exclusive to Napoleon® Fire-
#3
#4
#5
19
#1
#2
W415-0326 / C / 11.23.07

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bgd48p

Table of Contents