Table of Contents
Advertisement
an Integral
The hood can be installed with a VTN IO00Q
blower.
Blower preparation
Wire tie
___-
Shipping brackets
Capacitor
Blower Front View
Figure 12a
1.
Remove left and right shipping
brackets
and discard.
2.
Cut wire tie shown in Figure 12a. Locate the
wire harness with the Molex 6-pin connector.
Route wire harness out rear of blower, as shown
in figure 12 b. below.
3.
Re-attach wire harnesses to capacitor with new
wire tie (supplied) in same location in front.
Blower
1
.
2.
Install blower in hood
The blower is attached to the hood using weld
studs provided on the mounting plate.
Figure 12c shows the weld studs in location B
for horizontal (rear) discharge. Attach four #10-
24 nuts to the weld studs. For vertical
discharge, attach nuts to studs at the top of the
mounting plate.
Figure 12c
Figure 12b
\
\
-,,.
Add wire tie
\-.
here
,,,.
"Wire
Harness
Blower Rear View
4.
Attach wire harness with Mobx 6-pin connector
to housing as shown in Figure 12b with wire tie
(supplied).
3.
Guide the motor mounting plate over the nuts
and tighten to secure the blower to the hood.
4.
Attach two additional screws as shown in
Figure 12d.
Ventill_
Assembl
Figure 12d
CAUTION
Verify that the two additional
screws
in
Figure
12d are
installed
and properly
tightened
before continuing.
Page 9
Advertisement
Table of Contents
