Table of Contents
Advertisement
Appliance Installation
The hood can be mounted on a wall or suspended
from a cabinet. Both vertical and horizontal
discharge are possible with either mounting method.
Discharge
Direction:
The hood is shipped ready for
vertical discharge. To change to horizontal discharge
move the discharge cover shown in Figure la to the
top of the hood. The plate is held in place by four
screws.
Assembly
of the Transition:
The supplied
transition mounts to the top or rear of the hood
depending on the discharge direction.
1. Align mounting holes at base of transition with
mounting holes on 1/2" flange located at the
top or rear of the hood depending on direction
of discharge.
2.
Fasten transition to hood using two (2)#8
sheetmetal screws (included with hood).
3.
Seal connection between transition and hood
with duct tape.
4.
Remove tape holding damper closed.
See Figure lb for overalt hood dimensions.
This opening is
covered for
horizontal
discharge
O
O
This opening is
covered for vertical
discharge.
Figure la: Discharge
Direction
Dimension A
Modet Number
PH30ZS
PH36ZS
PH42ZS
PH48ZS
PH54ZS
Dimension
30"
36"
42"
48"
54"
Figure lb: Overall Dimensions
Page 4
Advertisement
Table of Contents
