Table of Contents
Advertisement
Cabinet Mnstallation
The hood can be installed under
a cabinet by supporting the
hood from the top.
Note: The cabinet must be
structurally
joined to the wall
studs to support
the weight
of this hood.
Figure 10 shows the four screw
holes (K) used for mounting the
hood to the bottom of the
cabinet.
Make sure both knockouts have
been removed.
1.
in the base of the cabinet
drill 1/8" tap holes (See
dimensionAin
Figure 10
and in Table). Screw in four
#10 x 1" screws (provided
with hood)leaving
1/4"
exposed).
2.
if the hood is installed for
vertical discharge, use
Figure 11 to create
clearance holes for passage
of the transition and conduit
(See dimension B in Figure
11 and in Table).
3.
For horizontaldischarge
use
Figure 5 for the geometry of
the cutout required for
clearance of the transition.
4.
Hang hood from screws and
tighten securely.
5.
From inside of hood, insert
screws supplied. Drill
through holes (use #8 x 5/
8" screws supplied), one on
each side and four along the
front, into bottom of the
cabinet.
See screws holes
labelled "L" in Figure 10.
1-9/16"
A:_ote
Locations
23"
J
J
J
J
Note: This figure depicts tap hole and
screw hole locations
only. See Figue lb,
page 4 for overall hood dimensions.
Figure 10: Tap Hote and Screw Hole Locations
Centerline Hole Dimensions
for Figures 10 and 11
Model
A (Fig 10)
B (Fig 11)
Tap
Holes
Conduit H ole
PH30ZS
29-1/1e"
13-7/16"
PH36ZS
35-1/1e"
187/16"
PH42ZS
41zl/le"
19-7/16"
PH48ZS
47-1/1e"
22-7/1e"
PH54ZS
53-1/16"
25-7/16"
Cooktop
_,_
Centerline
5/8"DIAclearance
3 -3/16"
holesfor 1/2"conduit
to i-box,
Plan View of Cabinet Cutout
Note: This figure depicts transition and conduit locations only. See Figure lb,
page 4 for overall hood dimensions.
Figure 11: Transition and Conduit Locations
Page 8
Advertisement
Table of Contents
