D-Link DSM-G600 Instruction Manual page 10

DSM-G600 User's Manual
D. While facing the back of the
DSM-G600, insert the right side of
the hard drive into the case. Once in
place, snap down the left side.
E. Use the mounting screw to secure
the hard drive to the DSM-G600.
Replace the cover and screw the
two screws on the back panel of the
DSM-G600.
F. Connect an Ethernet cable to the
Ethernet jack located on the back of
the DSM-G600 for initial setup.
Note:
configuration is set, you may disconnect the Ethernet cable and begin communicating wirelessly
with your DSM-G600.
D-Link Systems, Inc.
It is required that an Ethernet cable is used during initial setup. Once your wireless
Hardware Installation
10