Panasonic CS-HE9JKE Service Manual page 83

16.2.3. Removal of Control Box
1. Remove the Control Board by releasing the hooks (four:
two each on the right and left).
2. Remove the screw (one) fixing the Control Box.
3. Remove a variety of connectors and Terminals.
• Compressor cables (red, blue and yellow)
...... Remove the Connector (white).
• CN-HOT ...... 4-way Valve
• CN-FM1 ...... Outdoor Fan Motor
• CN-STM ...... Expansion Valve
• CN-TH
...... Sensor Complete (Outdoor Air/Pipe Temp.)
• CN-DIS
...... Sensor Complete (Discharge Air Temperature)
• Reactor Connectors (two)
4. Remove the interconnect cables and the Earth Wire (one
screw).
• Interconnect cables (red, white and black)
......... Disconnect them from the Terminals.
• The earth terminal (yellow-green)
......... Remove it by unscrewing. (one screw)
• Remove the screws (two) fixing the Terminal part and the
Cabinet Side Plate.
Fig. 5
Fig. 6
Fig. 7
5. Remove the Control Box from the unit by holding it up.
16.2.4. Removal of Control Board
1. Remove the Cabinet Top Plate and Cabinet Front Plate
according to 16.2.1.
2. Remove the Control Cover and Terminal Cover according
to 16.2.2.
3. Remove the Control Box according to 16.2.3.
4. Disconnect the Control Terminals (Four cables).
5. Place the Control Box reversely and remove the screws
(two) on the both sides of the Control Box B (for Terminal
Plate).
83
Fig. 8
Fig. 9
Fig. 10