Maintenance Guidelines; Cleaning The Monitor - HP 27SV User Manual

Maintenance Guidelines

Cleaning the Monitor

ENWW
cord. Look on the power label to determine the ampere rating (Amps or A) for
each device.
• Install your monitor near a power outlet that you can easily reach. Disconnect the
monitor by grasping the plug firmly and pulling it from the outlet. Never disconnect
the monitor by pulling the cord.
• Do not allow anything to rest on the power cord. Do not walk on the cord.
To enhance the performance and extend the life of the monitor:
• Do not open the monitor cabinet or attempt to service this product yourself. Adjust
only those controls that are covered in the operating instructions. If the monitor is
not operating properly or has been dropped or damaged, contact an authorized
HP dealer, reseller, or service provider.
• Use only a power source and connection appropriate for this monitor, as indicated
on the label/back plate of the monitor.
• Be sure the total ampere rating of the products connected to the outlet does not
exceed the current rating of the electrical outlet, and the total ampere rating of the
products connected to the cord does not exceed the rating of the cord. Look on
the power label to determine the ampere rating (AMPS or A) for each device.
• Install the monitor near an outlet that you can easily reach. Disconnect the
monitor by grasping the plug firmly and pulling it from the outlet. Never disconnect
the monitor by pulling the cord.
• Turn the monitor off when not in use. You can substantially increase the life
expectancy of the monitor by using a screen saver program and turning off the
monitor when not in use
• Slots and openings in the cabinet are provided for ventilation. These openings
must not be blocked or covered. Never push objec ts of any kind into cabinet slots
or other openings.
• Do not drop the monitor or place it on an unstable surface.
• Do not allow anything to rest on the power cord. Do not walk on the cord.
• Keep the monitor in a well-ventilated area, away from excessive light, heat or
moisture.
• When removing the monitor base, you must lay the monitor face down on a soft
area to prevent it from getting scratched, defaced, or broken.
1. Turn off the monitor and the computer.
2. Unplug the monitor from the wall outlet or the power brick.
3. Clean the monitor plastics with a clean cloth dampened with water.
4. Clean the monitor screen with an antistatic screen cleaner.
CAUTION: Do not use benzene, thinner, ammonia, or any other volatile
substances to clean the monitor or the screen. These chemicals may damage the
cabinet finish as well as the screen.
3
Maintenance Guidelines