Sony DCR-SR210E Service Manual page 14

1-3-3. E : 62 : 12 [Shift Lens Overheating (Yaw)] Occurred
Connect by the SeusEX and perform the following process.
Order Block Page Address Data
1 11 80
2 11 8E
3 11 8E
4 11 8E
5 11 8E
6 11 8E
7 11 8E
8 11 80
9
10
11
12
13
14
Note 1: Finish this operation within 10 seconds. If it is likely to take more than 10 seconds, set block: 11, page: 8E, address:
F949, data: 00, and then retry.
Note 2: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
1-3-4. E : 62 : 20 [Abnormality of Thermistor] Occurred
Order
1 Turn the power ON.
Confirm the connections of flexible flat cables and connectors between the lens block and LD-230 board, LD-230 board and
2
VC-516 board.
In case of no malfunction of connections, replace the lens block with new one. (Note) When the error has occurred in spite of the
3
lens replacement, replace LD-230 board with new one.
Note: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
DCR-SR210E/SR220/SR220D/SR220E/
HDR-SR10/SR10D/SR10E_L2
7430 01 Write the data. (After it starts, set it before caution is displayed.)
F947 F0 Write the data.
F949 01 Write the data. (Note 1)
F949 00 Write the data.
F947 10 Write the data.
F949 01 Write the data. (Note 1)
F949 00 Write the data.
7430 00 Write the data.
Check if the shift lens moves while setting the order 2 to 7. If the shift lens does not move,
replace the lens block (Note 2). When the shift lens moved, proceed to the order 10.
While setting the order 2 to 7, measure with an oscilloscope the output voltage of R5534 in the
periphery of IC5501 on the LD-230 board to check the output voltage varies.
If the output voltage does not vary, replace the lens block (Note 2). When the output voltage
varied, proceed to the order 12.
Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501
on the LD-230 board, turn the power ON to check that the output voltage immediately after the
power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note 2). If it does not
change as shown in Fig. 2, inspect the camera control circuit (IC1301 of VC-516 board)
periphery.
Procedure
Procedure
1-5
ENGLISH JAPANESE
ENGLISH JAPANESE