Table of Contents
Advertisement
Safety Labels
The following WARNING LABELS are found on your cleaning unit. These labels point out important Warnings and
Cautions which should be followed at all times. Failure to follow warnings and cautions could result in fatality,
personal injury to yourself and/or others, or property damage. Follow these instructions carefully! DO NOT remove
these labels.
NOTE: If at any time the labels become illegible, promptly replace them.
CAUTION
Caution Label
P/N 86352580
Installation on vehicle fuel door.
VACUUM
LUBRICATION
LUBRICATE
WITH VACUUM
INLETS SEALED
CHEMICAL
CHECK
VALVE
SOLUTION
SCREEN
SOLUTION OUTLET
Caution Label
P/N 86186530
86317260 BLAZER GT
LUBRICATE REGULATOR SEALS
EVERY 50 HOURS.
RECOMMENDED LUBRICANT:
SYNCO SUPER LUBE
SOLUTION PRESSURE
REGULATOR
CONDENSED OPERATING INSTRUCTIONS
CONDENSED OPERATING INSTRUCTIONS
STARTING
STARTING
1. CONNECT WATER HOSE TO WATER INLET CONNECTION AND TURN ON WATER
SUPPLY.
2. CONNECT SOLUTION AND VACUUM HOSE TO THE DESIRED CLEANING TOOL
AND TO THE CONSOLE.
3. PULL OUT THROTTLE 3/4 INCH.
4. PULL OUT ENGINE CHOKE. TURN WASTE PUMPOUT SWITCH TO OVERRIDE
SOLUTION TEMPERATURE
POSITION AND TURN IGNITION SWITCH TO START.
CONTROL
5. PUSH IN CHOKE AND RELEASE OVERRIDE SWITCH AFTER ENGINE HAS
STARTED.
6. INSERT CHEMICAL INLET AND PRIME HOSES INTO CHEMICAL CONTAINER.
7. ROTATE CHEMICAL VALVE TO PRIME AND
FLOW THROUGH THE CHEMICAL CIRCUIT. AFTER ALL AIR BUBBLES
WARM
HOT
HAVE BEEN REMOVED, TURN THE CHEMICAL VALVE TO THE ON
POSITION.
8. TURN THE CHEMICAL VALVE TO RUN, OPEN THE VALVE ON THE CLEANING
TOOL AND SET THE CHEMICAL FLOW VALVE TO THE DESIRED CHEMICAL
FLOW RATE WHILE OBSERVING THE FLOW METER.
9. SET THROTTLE TO THE DESIRED OPERATING SPEED.
10. FOR QUICK HEAT-UP REFER TO THE OPERATING INSTRUCTION MANUAL.
Lower Front Panel Decal
with warning labels
P/N 86316190
Safety
SHUTDOWN AND DAILY MAINTENANCE
1. TURN CHEMICAL VALVE TO THE OFF POSITION, AND REMOVE THE
VACUUM HOSE.
2. ALLOW THE UNIT TO RUN FOR 2 MINUTES WITH THE VACUUM HOSE
DISCONNECTED TO REMOVE MOISTURE THEN SPRAY A WATER
DISPLACEMENT/LUBRICANT INTO THE VACUUM LUBRICATION CUP.
THIS WILL PREVENT CORROSION DUE TO MOISTURE.
3. PUSH THE THROTTLE "IN" TO THE IDLE POSITION AND OPEN THE
TEMPERATURE BYPASS VALVE FOR 2 MINUTES ALLOWING THE UNIT
TO COOL DOWN.
4. TURN OFF IGNITION SWITCH.
5. DISCONNECT ALL HOSES AND TOOL S.
ALLOW CHEMICAL TO
6. DRAIN WASTE TANK INTO AN APPROVED SOURCE AND CLEAN THE
STRAINER BASKET AND WASTE TANK FILTER.
Warning Label
P/N 86186520
9
Advertisement
Table of Contents
