Table of Contents
Advertisement
Figure 10 Securing the rear of the enclosure in the rack (view from front of rack)
4.
Reattach the front bezel covers.
5.
At the rear of the rack, loosen the thumbscrew on the shipping retaining bracket (1,
Figure 1 1 (page
chassis. Tighten the thumbscrew on the bracket.
Figure 1 1 Securing the rear of the enclosure (view from rear of rack)
6.
Repeat
1
Installing the hard drives into the drive bays
After the disk enclosures are secured in the rack, install the hard drives into the drive bays. Drives
must be installed in the proper bay sequence (see
optimum HP P6000 Command View performance and data integrity.
For example, if you have four enclosures, and eight drives, you should install four drives into bay
1 of each enclosure and four drives into bay 2 of each enclosure. Do not install all the drives into
enclosure 1 and leave the other enclosures empty.
16
Install components
16)) and slide the bracket forward (2) until the tab engages the slot in the
through
5
to install the controller enclosures.
Figure 12 (page
17)) in the enclosures for
Advertisement
Table of Contents
