Installation; Install Electronic Head - Pelican PS48 Owner's Manual

PS48/PS80 Advantage Series Salt Based Water Softeners

Installation

Install Electronic Head

Incoming
Water
Supply
Figure 3
Notice:
Follow the raised black arrows on the head of the Softener.
1. Level the Pelican Softener Tank.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line and choose the appropriate
fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
3. Remove the gray cap from the top of the Softener tank.
4. Remove blue cap from the distributor tube.
5. Screw the Electronic Head onto the tank hand-tight.
6. Install the appropriate fittings onto the inlet and outlet, following the arrows on the Bypass Valve
and head.
7. Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.
8. Connect the outgoing water supply to the outlet side of the Bypass Valve.
9. Firmly press one end of the discharge PVC Tubing Drain Line onto the barbed nose, and secure the
other end of the line to a drain.
© 2015 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Wall
Safety Valve
Holding Tank
Brine Tank
Bypass
Valve
Overflow
Barb
Softener Tank
— Rev K
Page 7
Outgoing
Water to
House
Electronic
Head
Discharge
Line
www.pelicanwater.com
(877) 842-1635