5.
Install receipt/journal paper.
To load 1-ply paper for printing of receipts
Roll paper spindle
Paper inlet
X
CAL
REG
Z
OFF
RF
PGM
1 1 1 1 1
Use a mode key to set the
mode switch to REG
position.
2 2 2 2 2
Remove the printer cover.
3 3 3 3 3
Cut off the leading end of
the paper so it is even.
4 4 4 4 4
Ensuring the paper is being
fed from the bottom of the
roll, lower the roll into the
space behind the printer.
Important!
Never operate the cash register without paper.
It can damage the printer.
1
2
5 5 5 5 5
Work the paper roll gently
between the two spindles
so that they slip into the
center hubs of the roll.
6 6 6 6 6
Insert paper to the paper
inlet.
7 7 7 7 7
Press the f key until
about 20 cm to 30 cm of
paper is fed from the
printer.
8 8 8 8 8
Replace the printer cover,
passing the leading end of
the paper through the
cutter slot. Tear off the
excess paper.
7