Maintenance - DeWalt D25052-XE Instruction Manual

DEPTH ROD (FIG. 5)
TO ADJUST THE DEPTH ROD
1. Push in and hold the depth rod release button (J) on the side handle.
2. Move the depth rod (D) so the distance between the end of the rod and the end
of the bit equals the desired drilling depth.
3. Release the button to lock rod into position. When drilling with the depth rod, stop
when end of rod reaches surface of material.
FIG. 6
D

MAINTENANCE

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Lubrication
Your tool was properly lubricated before leaving the factory. In from two to six
months, depending upon use, take or send your tool to an authorized service
center for a complete cleaning, inspection and lubrication. Tools used constantly on
production jobs will need relubrication more often. Also, tools "out of service" for long
periods should be relubricated before being put back to work.
J
9
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
Accessories
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D WALT recommended accessories should be used
E
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 338 002 or (NZ) 0800 339 258.
WALT, have not been
E