Table of Contents
Advertisement
Connecting
to the network
using the WPS setting
o
amsung washers use PBC as the WPS type, Check if the current wired/wireless router
supports Wi-Fi Protected Setup:M(WPS).
o Check if the wired/wireless share has a WPS button,
1. Press and hold both the Temp. and Start/Pause
buttons
for 5 seconds,
2. Turn the Cycle Selector
until "UP" is displayed on the
display panel and press the Start/Pause
button,
lf the connection is not established within 5 minutes,
"FUP" is displayed on the display panel.
3_
4_
Press and hold the WPS button of the wired/wireless
router that will be connected with the washer for 120
seconds or less to run the WPS function of the wired/
wireless router, If the WPS function runs, the wired/wireless
router automatically fetches the necessary information from
the washer and the washer is automatically connected to
the Internet through the wired/wireless router,
@
How to use the WPS function of the wired/wireless router may differ depending on
the manufacturer, Refer to the user manual of the corresponding wired/wireless
router,
Even after the WPS setup is complete, it may take some time until the actual
connection is established to allocate an IP address through DHCP (up to 5 minutes),
CAUTION
Note that if you use a wired/wireless router that is not WPS-certified, the washer
may not be connected through Wi-Fi or a device that was connected to the wired/
wireless router may be disconnected,
Please note that for some wired/wireless touters, if you press and hold the WPS
button for some time, the settings of the router may be reset,
If the washer and the wired/wireless router are propedy
connected, the _
indicator blinks on the display panel for
30 seconds.
Press the Smart Controm button to finish the Smart
Control connection setup. When the setup is completed
......
normally, the _
indicator blinks on the display panel with a
...............
beeping sound.
lf you press the Smart Control button when the washer and the wired/wireless router
are not properly connected, the invalid button sound is heard and the Smart Control
connection setup is not completed.
32 wasl!":ng a cad of aundry
Advertisement
Table of Contents
