Mode Button - RIEJU MRT 50 Chassis Workshop Manual

Electrical system
Oil alarm
The OIL alarm displays the (
This alarm is triggered when a low oil level activates the electrical contact, and turns off
when the oil level is higher than the minimum and the contact opens.
To prevent false messages, the alarm delays 5 seconds in turning on and off.
DIAGNOSIS (only on machines with a cubic capacity greater than 50cc)
Each time the ECU sends an error message, the dashboard activates the alarm procedure;
the Wtemp LED flashes depending on the error sent by the ECU, and the (
lights up on the screen.
units 0,5 s on + 0,5 s off
tens 1,0 s on + 1,5 s off
start 3,0 s pause
end 3,0 s pause
Comment: If the WTEMP alarm is activated, the LED will light up until the WTEMP alarm
disappears.

MODE BUTTON

The mode button enables the user to:
• scroll through the different functions;
• reset the trip meter, the average speed, the chronometer and the maximum speed to zero.
• enter into the configuration menu.
Scrolling through the different functions can be performed at all times, and does not de-
pend on the speed of the machine. To change the function, press the button for a moment
(tmin = 1 s). It is always possible to reset TD, AVE, LAP and MAX to zero; this does not
depend on the speed of the machine.
It is only possible to enter the configuration menu when the speed=0.
The mode button is active when the engine is running in a machine without a battery (?) or
when the key is inserted in all other models.
Sequence of functions
Short press
TOTAL TD
ADJUST UNIT OF MEASUREMENT
ADJUST CIRCUMFERENCE
if this is allowed
ADJUST CIRCUMFERENCE
if this is allowed
) symbol on the LCD, and the corresponding LED lights up.
AVE
Chassis
) symbol
LAP MAX
69