Emerson HC1100 Installation, Care & Use Manual page 9

5
FINAL WATER CONNECTION
UK/IRL
A
Property Damage: Join remaining tube
to cold water supply only.
A
Property Damage: Join remaining tube
to cold water supply only.
6
FILL TANK & THEN CONNECT POWER
A
Scalding Hazard: The tap dispenses water up
to 98ºC, which can instantly cause scalds or burns.
Use care when operating this appliance.
B
Property Damage: A standard earth (grounded) outlet
within 760mm of the tap is required under the sink.
Do not use an extension cord set with the tap.
AUS/NZ
HC1100 / GN1100
At the other end of the white tube from
the filter, press on the:
H990
I I
(UK/IRL) 9.5mm to 15mm quick-connector
and connect to a 15mm water supply.
I I
(AUS /NZ) 3/8" to 1/4" bspt John Guest
fitting and connect to a female 1/4" bspt
fitting water supply.
I I
Press in again to ensure a secure fit.
I I
At the end of the copper tube, press on
the 1/4" to 1/4" bspt John Guest fitting
and connect to a female 1/4" bspt fitting
water supply. (not included)
I I
Press in again to ensure a secure fit.
I I Turn on the cold water supply.
I I Depress or twist the tap's
handle and hold it until water flows
from the spout.
I I Run the water for at least 2 minutes to
flush lines (both the hot and cold handles
independently if applicable).
I I
Check all connections to ensure they are
tight and that there are no leaks.
I I
Plug in tank and ensure that green light
on front of tank is illuminated.
Water will be cold at first.
Allow 12-15 minutes for water to reach
target temperature.
Gurgling or hissing is normal during the
initial heating cycle.
HOT
9