Do you have a question about the 60-1609-4 and is the answer not in the manual?
Questions and answers
Monica Harvey
May 31, 2025
What horse power is this mower?
2 comments:
Monica Harvey
May 31, 2025
@Monica Harvey The model number is 60-1609-4
Mr. Anderson
May 31, 2025
The Yardworks mower with part number 60-1609-4 has a 173cc engine. The horsepower is not specified.
This answer is automatically generated
Jamie Toro
May 12, 2025
How do you change front wheels
1 comments:
Mr. Anderson
May 20, 2025
To change the front wheels on a Yardworks model with part number 60-1609-4, follow these steps:
1. Turn Off and Secure the Equipment: Ensure the lawn mower is turned off and the spark plug is disconnected for safety.
2. Tilt the Mower Safely: Tilt the mower backward or to the side so you can access the front wheels. Use a block or stand to stabilize it.
3. Remove the Wheel Cover (if present): Some models have a plastic cap over the wheel hub. Pry it off using a flathead screwdriver.
4. Remove the Retaining Hardware: Use a wrench or socket to remove the nut, bolt, or clip holding the wheel in place. Keep these parts in a safe place for reassembly.
5. Take Off the Old Wheel: Slide the wheel off the axle or shaft.
6. Install the New Wheel: Slide the new wheel onto the axle, aligning it properly.
7. Reattach the Retaining Hardware: Secure the wheel with the nut, bolt, or clip you removed earlier. Tighten it firmly.
8. Replace the Wheel Cover: If your model has a wheel cap, snap or press it back into place.
9. Lower the Mower and Reconnect the Spark Plug: Return the mower to its upright position and reconnect the spark plug.
Make sure the wheel spins freely and is securely attached before use.
Need help?
Do you have a question about the 60-1609-4 and is the answer not in the manual?
Questions and answers
What horse power is this mower?
@Monica Harvey The model number is 60-1609-4
The Yardworks mower with part number 60-1609-4 has a 173cc engine. The horsepower is not specified.
This answer is automatically generated
How do you change front wheels
To change the front wheels on a Yardworks model with part number 60-1609-4, follow these steps:
1. Turn Off and Secure the Equipment: Ensure the lawn mower is turned off and the spark plug is disconnected for safety.
2. Tilt the Mower Safely: Tilt the mower backward or to the side so you can access the front wheels. Use a block or stand to stabilize it.
3. Remove the Wheel Cover (if present): Some models have a plastic cap over the wheel hub. Pry it off using a flathead screwdriver.
4. Remove the Retaining Hardware: Use a wrench or socket to remove the nut, bolt, or clip holding the wheel in place. Keep these parts in a safe place for reassembly.
5. Take Off the Old Wheel: Slide the wheel off the axle or shaft.
6. Install the New Wheel: Slide the new wheel onto the axle, aligning it properly.
7. Reattach the Retaining Hardware: Secure the wheel with the nut, bolt, or clip you removed earlier. Tighten it firmly.
8. Replace the Wheel Cover: If your model has a wheel cap, snap or press it back into place.
9. Lower the Mower and Reconnect the Spark Plug: Return the mower to its upright position and reconnect the spark plug.
Make sure the wheel spins freely and is securely attached before use.
This answer is automatically generated