DeWalt DW677 Original Instructions Manual page 18

E N G L I S H
Also refer to the table below.
Conductor size (mm 2 )
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
115 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Adjusting the depth of cut (fig. B)
• Turn the planing depth adjustment knob (4).
One revolution of the adjustment knob equals a
1.5 mm change in depth. One graduation
corresponds to a depth of cut of 0.1 mm.
Attaching and removing the parallel fence
(fig. A & C)
The parallel fence (12) is used for optimum tool
control on narrow workpieces.
• Slacken the wing bolt (6).
• Fit the parallel fence (12) in the hole (7) from
either side.
• Tighten the wing bolt.
• To remove the parallel fence, proceed in reverse
order.
Removing reversible cutters (fig. D)
• Loosen the three bolts (13) with the spanner (14)
supplied.
en - 4
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5 15 25 30 45
Cable rating (Amperes)
6 6 6 6
6 6 6 6 15
6 6 10 15 20
10 10 15 20 20
15 15 20 25 25
20 20 25 -
6 6 6 6
6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 20 25
• Flap the side guard (8) up.
• Slide the cutter (15) out of its holder.
• Reverse the cutter or replace it.
• Slide the cutter into the holder. Make sure that
the cutter is flush with the planing shoe (16).
• Tighten the three bolts (13).
60
Instructions for use
6 10
15
20
25
-
Prior to operation:
- -
• Adjust the depth of cut.
6 6
• If necessary, fit and adjust the parallel fence.
6 6
15
15
20
-
Switching ON and OFF (fig. A)
Your Planer is equipped with a safety switch to
prevent inadvertent operation.
• Switching ON: press the lock-off button (2) and
subsequently press the ON/OFF-switch (1).
• Release the lock-off button (2).
• Switching OFF: release the ON/OFF-switch (1).
Always switch OFF the tool when work is finished
and before unplugging.
Planing (fig. A)
• Switch the tool ON as described.
• Slowly move the Planer over the workpiece.
• The feed speed should not be too high,
• Remember that several shallow cuts are
• Switch the tool OFF.
Your Planer is equipped with a parking shoe (11).
After switching OFF the tool can be put down
without waiting for the cutters to come to a
standstill.
Always replace both cutters.
Always observe the safety instructions
and applicable regulations.
Use sharp cutters only.
especially when using the maximum
depth of cut and planing width.
better than one deep cut.
14