Advertisement
Quick Links
Advertisement
Related Manuals for Omega ORF60X
Summary of Contents for Omega ORF60X
- Page 1 Instruction Manual for Rangehood Models: ORF60X ORF90X...
-
Page 2: Table Of Contents
It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Omega reserves the right to alter specifications or appearances without notice. Dispose of packaging responsibly – recycle where facilities are available. -
Page 3: Warning
WARNING • Young children should be supervised to ensure that they do not play with the appliance. • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervised or instruction concerning use of the appliance by a responsible person for their safely. -
Page 4: Installation Instructions
4. INSTALLATION INSTRUCTIONS Method one: 1) The cooker hoods should be placed at a distance of 65-75cm from the cooking surface for best effect. 2) To install onto the wall, drill 4 holes of Ø 8mm at a suitable place according with the centre distance of hole in the back of the cooker hood. -
Page 5: Attention
Method two: 1) Drill 6 holes of Ø 4mm at the bottom of the hanging cupboard. 2) Put the one way valve on the cooker hood, then install the cooker hood on the bottom of the cupboard, tighten the hood with enclosed 6 screws. 3) Install the adjusted board on the bottom of the hood in order to keep out the gap between hood back and cupboard. -
Page 6: Operation
6. OPERATION Outdoor air ventilation: Turn the adjuster to outdoor position(pic.5A), install the outlet, turn on the cooker hood, then the air will be vented from the outside outlet. Indoor air ventilation: Turn the adjuster to indoor position (pic.5B), install the outlet cover, turn on the cooker hood, then the air can be vented from the inside outlet. -
Page 7: Light Replacing
7. MAINTENANCE Changing and cleaning the filter as below (pic7): Put the filter into the water of 40-50℃,Put some detergent in, and leave it for 2-3 minutes. Then use the soft brush to clean it with proper strength, in order not to damage the filter.