The Keypad - Inner Range Concept 4000 User Manual

CONCEPT 4000. CONCEPT 4000.
CONCEPT 4000. CONCEPT 4000. CONCEPT 4000.
10

The Keypad.

Operations & programming are performed by using the keypad on an LCD Terminal.
The functions of the 20 keys during User Operations are described below.
Each time a key is pressed, a short "beep" will be
emitted to indicate that the key press was accepted.
(The Installer can disable the beeping if necessary)
If the Terminal emits a long "beep", it means that the
key press was not accepted or is not allowed.
You may only press one key at a time but key press
sequences may be as fast as you like.
The DIGIT keys are used for entering your secret PIN code.
You have 10 seconds to enter each digit, and must press the
<OK> key when complete.
This sequence is required before any panel operations can be
performed.
These keys can also be used to search for an item to be
controlled by selecting the first letter of it's name.
The <OFF> and <ON> keys are used to turn Off or turn On,
the Area (or Area List) named on the Display at the time.
The <HELP> key is used to display a "Help message" about
the current operation being performed and can be pressed at
any time.
The <MENU> key is pressed after PIN code + <OK> if you
wish to perform any Menu operations. (Operations other than
Area On/Off, Door Access, etc.)
OR if pressed when not logged on, may allow Review of past
Alarms, if enabled (V3 or later), and System information.
The <END> key is used when you have finished performing
the required operations or if you make a mistake while entering
your PIN code and want to start again.
User Manual.