Helpful Tips And Guide; Fault Code; Technical Problems - Currys Essentials CDW45W10 Installation Instructions Manual

Helpful Tips and Guide

Repairs should only be carried out by a qualified technician in strict accordance with current local
and national safety regulations. Unauthorised or incorrect repairs could cause personal injury or
damage to the unit.
Before calling for service, please refer to Helpful Tips and Guide to solve some general problems by
yourself.

Fault Code

Codes
Light is flashing.
Light is flashing.

Technical Problems

Problem
The dishwasher does not start.
The drain pump is not working
properly.
Problem
Detergent residue is left at the
end of the programme.
The detergent dispenser lid
cannot be closed properly.
Knocking noise in the wash
cabinet.
Smearing appears on glassware
and cutlery.
22
Possible Causes
Water tap is not turned on.
Low water pressure (<0.04MPa)
Flow meter is broken.
The wire terminals which connect
the flow meter are loose.
The tank is leaking.
The hose is leaking.
The float switch is broken or PCB
is faulty.
Technical Problems
Possible Causes
The door is not properly closed.
The unit is not connected to the
mains.
The unit is not switched on.
The anti-flooding system has
operated.
General Problems
Possible Causes
The detergent slot was still
damp when detergent was
added.
Clogged detergent residue is
blocking the catch.
A spray arms is knocking against
an item in a basket.
The rinse aid dosage is set too
high.
Remedy
Turn on the water tap.
Turn on the water tap and
ensure it is in full position.
Disconnect from the mains.
Disconnect the water inlet.
Call a qualified technician.
Remedy
Close the door firmly.
Insert the plug to the mains.
Press the On/Off button and select
a programme.
Disconnect from the mains.
Disconnect the water inlet.
Call a qualified technician.
Remedy
Make sure the slot is dry before
adding detergent.
Clean the catch.
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm. See the
section "Loading the dishwasher".
Adjust the dial of the rinse aid
dispenser to a lower setting.