Adjustments - Polaris Sportsman Big Boss 6X6 Owner's Manual For Maintenance And Safety

ADJUSTMENTS

Camber and Caster
The camber and caster are non-adjustable.
Rear Springs
The rear shock absorber springs are
adjusted by rotating the adjusters either
clockwise or counter-clockwise to
increase or decrease spring tension.
Always adjust all rear springs to equal
settings.
Accessory springs are available through
your POLARIS dealer.
Handlebars
The handlebars can be adjusted for rider preference.
WARNING! Improper adjustment of the handlebars or incorrect torquing of the
adjuster block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your POLARIS dealer for service.
1. Remove the upper headlight
pod.
2. Loosen the four handlebar
bolts.
3. Adjust the handlebar to the
desired height. Be sure the
handlebars do not contact the
gas tank or any other part of
the machine when turned fully
to the left or right.
4. Torque the front two bolts to
10-12 ft. lbs. (14-17 Nm), then
torque the rear two bolts. A
gap of up to 1/8" (3 mm) will
remain at the rear of the clamp
blocks.
116
Adjuster
Handlebar
Bolts