Installing The Flight Pack Into The Fuselage; Pre-Flight Test - MegaTech Cosmic Flyer Flight Manual

Installing the Flight Pack into the Fuselage

• Gently lift and open the battery hatch on the front of the
Cosmic Flyer fuselage.
• Leave all foam pieces inside of the
fuselage to ensure proper placement
of the fl ight pack.
• Place battery into fuselage with the
wide section of the battery toward
the front as shown. (Figure 10)
• Attach the battery connector to the
connector inside the fuselage,
gently close the hatch and secure w/
rubber band around fuselage
Figure 11 - Trim Tabs
• Move the right control stick of your transmitter all the way to the right.
a. The vertical part of the tail should move to the right.
b. Now move the right control stick all the way to the left. The
opposite function should occur.
• Now press the Motor Start Button on the side of the fuselage. The motor
should not start until this safety switch is pushed. Now push the left
control stick forward. The propeller should now spin rapidly and stop
when the control stick is back in its neutral state.
Caution: Keep hands, clothing and loose objects away from the propeller!
Control Stick Left
Figure 10 - Battery Placement
Pre-flight Test
• Begin by centering the trim tabs • Begin by centering the trim tabs
on on your transmitter (Figure 11).
• Turn your transmitter on fi rst, then • Turn your transmitter on fi rst, then
install a charged battery into your install a charged battery into your
plane. plane.
• Hold your plane in one hand, with • Hold your plane in one hand, with
your your fi ngers and loose objects away
from the propeller. from the propeller.
Control Stick Right
7