Charging The Flight Pack Battery; Attaching The Tail & Landing Gear - MegaTech Cosmic Flyer Flight Manual

Table of Contents

Charging the Flight Pack Battery

• Connect the battery to the wall charger.

• Note: Only use the included charger or one that is approved for use

with this battery.

• Plug the charger into an electrical outlet.

• Children must have parental supervision during the charging process.

• Charge the battery for 1-2 hours.

• Always monitor the charging process. The ﬂ ight pack should

become good and warm, but do not let it become extremely

become

hot! DO NOT OVERCHARGE THE BATTERY. Use extra

hot! DO NOT

caution when touching the battery because it may become very

hot.

Attaching The T-Tail & Landing Gear

• Remove the nuts from the threaded shafts on the Vertical Tail/Rudder and put

them in a safe place as you will need them to complete the assembly process.

• Slide Vertical Tail/Rudder through the Horizontal Tail/Elevator making sure to

line up A to A and B to B as shown (Figure 1).

• Locate the wire pushrod which is attached to the tail boom of the airplane.

Slide the end of the pushrod through the outermost hole of the control horn

located on the Vertical Tail/Rudder as shown (Figure 2).

Figure 1

• We use the latest NiMH (nickel-metal-

hydride) technology available. Do not

be alarmed by short ﬂ ight times at ﬁ rst.

NiMH batteries do not achieve their full

potential until they have been charged and

discharged 3 or 4 times. After that, you

should be attaining full ﬂ ight times.

NEVER LEAVE A CHARGING

BATTERY UNATTENDED!!

Always let the ﬂ ight pack cool before

recharging.

Figure 2

Table of Contents

Do you have a question about the Cosmic Flyer and is the answer not in the manual?