Right Crankcase Half - Beta Enduro RR 350 2013 Workshop Manual

1
2
1
Safety devices present on the inside of the right cran-
kcase half.
Location of piston oil jets.
40
3
4
7
9
8
1
1
DISASSEMBLY OF PARTS FROM
.12
CRANKCASES
Once the crankcases have been detached, it is
necessary to remove the various components
attached to it.
The correct positioning of some bearings ap-
plied to the crankcase halves is ensured by lo-
cking devices such as plates or simple screws.
In order to disassembly these bearings, the
safety devices must be disassembled as well.
1

RIGHT CRANKCASE HALF

.12.1
6
On the inside, the plates 1 are those which assu-
re the correct positioning of the support bearing
of the crankshaft. All you need to do is remove
the two screws 2 to disassemble them.
5
The plate 3 is the one relative to the mainshaft
support bearing of the gearbox. It can be disas-
sembled by removing the two screws 4.
The plate 5 holds the bearing of the secondary
shaft of the gearbox in place. It can be disassem-
bled by removing the two screws 6.
The screw 7holds the support bearing of the de-
smodromic device in place.
The oil seal blocking plate 8 is applied on
the outside. It can be removed by taking off
the two screws 9.
1
PISTON OIL JETS
.12.1.1
It is recommended to remove the piston oil
jets 1 and relative O-rings in order to check
and clean the lubrication circuit.
The oil jets are located inside of the right
crankcase half.