Table of Contents
Advertisement
5. Getting started
5.1 Remote control
• Open the battery compartment cover. It is located on the
rear of the remote control.
• Pull the closing tab back (if present) and lift the cover.
With other models of remote control, it suffices to simply
push the casing in the direction indicated.
A: Closing tab
Insert the batteries provided, paying attention to match the
polarities correctly. The correct polarity is indicated by the
plus and minus symbols in the battery compartment.
B: Sliding cover
5.2 Radio – Connecting and starting up
Connect the network cable to a properly installed and
easily accessible network socket.
The power supply unit is suitable for mains voltages
between 100 and 240 V, and is thus operable on almost
any AC power grid. Please note that a country-specific
adapter may be necessary.
You can find an appropriate selection of Hama products at
www.hama.com.
Note
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• When using a mult-socket power strip, make sure
that the sum power draw of all the connected devices
does not exceed its maximum throughput rating.
• If you will not be using the product for a long period
of time, disconnect it from mains power.
Once the product has been connected to mains power,
initialisation takes place.
The radio starts up.
To assist you in first-time setup of the radio, a Setup
Wizard is provided.
10
Advertisement
Table of Contents
