Specifications - Makita HR4002 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Lock button
3-1. Change lever
3-2. Pointer
3-3. Lock button
5-1. Side handle
5-2. Clamp nut
6-1. Side grip

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : chiseling function
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
7-1. Bit shank
7-2. Bit grease
8-1. Bit
8-2. Chuck cover
9-1. Bit
9-2. Chuck cover
10-1. Pointer
10-2. Change lever
Model
Carbide-tipped bit
Core bit
-1
)
Overall length
Net weight
Safety class
) : 92 dB(A)
pA
) : 103 dB(A)
WA
value (tri-axial vector
2
) : 10.5 m/s
h,CHeq
2
2
) : 17.5: m/s
h,HD
2
ENE044-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG102-3
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG215-2
For European countries only
sum)
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
ENG303-2
Rotary Hammer
Model No./ Type: HR4002
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
3
10-3. Lock button
11-1. Pointer
11-2. Change lever
11-3. Lock button
12-1. Depth gauge
12-2. Clamp screw
12-3. Grip base
14-1. Blow-out bulb
HR4002
40 mm
105 mm
680
2,500
458 mm
6.6 kg
/II
Corporation as the
ENG901-1
ENH101-13
responsible