Description (Fig. 1); Electrical Safety; Using An Extension Cable; Assembly And Adjustments - DeWalt DWE575 Original Instructions Manual

1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.

Description (fig. 1)

WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger switch
b. Trigger switch lock-off button
c. Main handle
d. Blade lock
e. End cap
f. Auxiliary handle
g. Bevel adjustment lever
h. Bevel angle adjustment mechanism
i. Base plate
j. Lower blade guard
k. Blade clamping screw
l. Lower guard lever
m. Upper blade guard
inTEnDED uSE
These heavy-duty circular saws are designed for
professional wood cutting applications. Do not
use water feed attachments with this saw. Do not
use abrasive wheels or blades. Do not use under
wet conditions or in the presence of flammable
liquids or gases.
These heavy-duty saws are professional power
tools. Do not let children come into contact with
the tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
e
accordance with EN 60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e

using an Extension Cable

If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm
is 30 m.
When using a cable reel, always unwind the cable
completely.

aSSEMBly anD aDjuSTMEnTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. An
accidental start-up can cause injury.

Changing Blades

To inSTall ThE BlaDE (fiG. 2–5)
1. Using the lower guard lever (l), retract the lower
blade guard (j) and place blade on saw spindle
against the inner clamp washer (n), making
sure that the blade will rotate in the proper
direction (the direction of the rotation arrow
on the saw blade and the teeth must point in
the same direction as the direction of rotation
arrow on the saw). Do not assume that the
printing on the blade will always be facing you
when properly installed. When retracting the
lower blade guard to install the blade, check
the condition and operation of the lower blade
guard to assure that it is working properly. Make
sure it moves freely and does not touch the
blade or any other part, in all angles and depths
of cut.
2. Place outer clamp washer (o) on saw spindle
with the beveled edge facing out. Make sure the
30 mm diameter on the blade side of the clamp
fits into the 30 mm hole in the saw blade to
ensure centering of the blade.
3. Thread the blade clamping screw (k) onto the
saw spindle by hand (screw has right-hand
threads and must be turned clockwise to
tighten).
4. Depress the blade lock (d) while turning the
saw spindle with the blade wrench (p) stored
underneath the main handle (c) (fig. 5), until
E n gl is h
; the maximum length
2
15