Kurzweil Mark-Pro 3i Owner's Manual page 21

Select a Setup
While you can play just one sound at a time within a program, a Setup consists of two or more
programs. Setup mode shines most during live performance. You can combine up to four distinct
sounds in a single setup to suit your need for band or solo performance situations.
The Mark Pro 3i has 16 setups.
The display for the setups
The display for the setups shows you the zone information. The 'zone' is a program within a
setup.
The upper line is the name and number of the setup and the lower line shows you each zone's
program number. In Setup mode, the Track 1~Track 3 buttons are lit and these buttons can
control correspond zones.
Zone Mute
The Track 1~Track 3 buttons can mute each zone.
If you press one of the Track buttons, its LED will turn off, an display will show that the zone will be
muted. (The figure below is an example of pressing Track 1 button)
When you press an unlit Track button, the zone will be enabled(un-muted).
Pedal setting for each zone
Sometimes, you may want to apply different pedal settings to different zones.
As needed, you can select the switch pedal to be enabled (on) or disabled (off). To do this, while
holding down a Track button, press a pedal. You can see a display as shown below, the status of
the corresponding zone and pedal.
Through this display, by repeating the process, you can confirm the state of each pedal enable.
Select a Setup 18