Makita EM2651UH Instruction Manual page 16

Petrol brushcutter
Hide thumbs Also See for EM2651UH:
Table of Contents

Advertisement

Available languages

Available languages

3) Primer pump
Continue to push the primer pump until fuel enters into the primer pump. (In
general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
4) Recoil starter
Pull the start knob gently until it is hard to pull (compression point). Then,
return the start knob, and pull it strongly.
Never pull the rope to the full. Once the start knob is pulled, never release
your hand immediately. Hold the start knob until it returns to its original
point.
5) Warm-up operation
Continue warm-up operation for 2 to 3 minutes.
Note: In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also, dry the electrode
section of the spark plug.
Caution during operation:
If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min
higher speed than required and at an approximate speed of 6,000 - 8,500 min
B: Startup after warm-up operation
1) Push the primer pump repeatedly.
2) Keep the throttle lever at the idling position.
3) Pull the recoil starter strongly.
4)     If  it  is  difficult  to  start  the  engine,  open  the  throttle  by  about  1/3.
Pay attention to the cutter blade which may rotate.
At times, such as winter, when starting the engine
is difficult
Operate choke lever with the following procedure when starting engine.
●   After  implementing  startup  steps  1)  to  3),  set  choke  lever  to  the  CLOSE  
position.
●   Implement  startup  step  4)  and  start  engine.
●   Once  engine  starts,  set  choke  lever  to  the  OPEN  position.
●   Implement  startup  step  5)  and  complete  warm  up.
CAUTION: If a bang (explosive sound) is heard and the engine stops, or the
just-started engine stalls before the choke lever is operated, return
the choke lever to the OPEN position, and pull the starter knob a
few times again to start the engine.
CAUTION: If the choke lever is left in the CLOSE position, and the starter knob
merely pulled repeatedly, to much fuel will be sucked in, and the
engine  will  become  difficult  to  start.
Primer Pump
Carburetor
-1
.
16
or more. Never operate the engine at a
-1
CLOSE
OPEN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Em2650uhEm2651lhEm2650lh

Table of Contents