Door Disassembly - Electrolux EI30BM55HB Technical & Service Manual

Door Disassembly

1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer case Removal")
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Remove the hood louver from the oven cavity.
(Refer to the procedure of "HOOD LOUVER
REMOVAL".)
5. Remove door assembly, refer to "Door
Replacement". Replacement of door components
are as follows:
6. Place door assembly on a soft cloth with latches
facing up.
NOTE: As the engaging part of choke cover and door
frame are provided at 16 places, do not force any par-
ticular part.
CHOKE COVER
7. Insert a putty knife (thickness of about 0.5mm)
into the gap A between the choke cover and door
stopper and between the choke cover and the
door frame as shown Figure C-3 to free engaging
parts.
8. Pry the choke cover by inserting a putty knife in
order shown in Figure C-3.
9. Now choke cover is free from door panel and door
frame.
LATCH SPRING, LATCH HEAD AND DOOR PANEL
10. Release the latch spring from the tab of the latch
head and tab of the door panel.
11. Release the latch head from the door panel.
12. Now, the latch spring, latch head and door panel
are free.
DOOR FRAME
13. Remove eight (8) screws holding the door panel
to the door frame assembly.
14. Release the door frame assembly from the door
panel.
NOTE: It is easier to release the engaging parts of
the upper or lower door hinge pin side at first.
15. Now, door frame assembly is free
Component Teardown
Door stopper
Choke cover
Figure C-3. Door Disassembly
4-15
A
Putty knife
Door frame