Door Disassembly - Electrolux E30MO65GSSA Service Manual

Hide thumbs Also See for E30MO65GSSA:

Factory parts catalog (8 pages)

Use & care manual (36 pages)

Installation instructions (4 pages)

Table of Contents

E30MO65GSSA

7. Make sure the door is parallel with oven face lines (left

and upper side lines) and door latch heads pass through

latch holes correctly.

8. Insert the lower oven hinge into oven cavity bottom flange

and then engaged the door hinge pin. Then secure the

lower oven hinge firmly with tree (3) mounting screws.

Note: After any service to the door;

(A) Make sure that door sensing switch and secondary

interlock switch are operating properly. (Refer to

chapter "Test Procedures".).

(B) An approved microwave survey meter should be

used to assure compliance with proper microwave

radiation emission limitation standards.

DOOR ADJUSTMENT

The door can be adjusted by keeping screws of each hinge

loose.

After adjustment, make sure of the following :

. Door latch heads smoothly catch latch hook through

latch holes and that latch head goes through center of

latch hole.

2. Deviation of door alignment from horizontal line of cavity

face plate is to be less than .0mm.

3. Door is positioned with its face pressed toward cavity

face plate.

4. Re-install outer case and check for microwave leakage

around door with an approved microwave survey meter.

(Refer to Microwave Measurement Procedure.)

Note: The door on a microwave oven is designed to act

as an electronic seal preventing the leakage of

microwave energy from oven cavity during cook

Remove door assembly, refer to "Door Replacement".

Replacement of door components are as follows:

. Place door assembly on a soft cloth with latches facing

up.

Note:

As the engaging part of choke cover and door panel

are provided at several places, do not force any particular

part.

2. Insert an putty knife (thickness of about 0.5mm) into the

gap between the choke cover and corner portion of door

panel as shown Figure C-6 to free engaging parts.

3. Lift up choke cover.

4. Now choke cover is free from door panel.

cycle. This function does not require that door be

airtight, moisture (condensation)-tight or light-tight.

Therefore, occasional appearance of moisture, light

or sensing of gentle warm air movement around

oven door is not abnormal and do not of themselves

indicate a leakage of microwave energy from oven

cavity. If such were the case, your oven could not be

equipped with a vent, the very purpose of which is to

exhaust the vapor-laden air from the oven cavity.

DOOR ASSEMBLY

Figure C-5. Door Replacement and adjustment