Table of Contents
Advertisement
Section 2: Operating Procedures
Instrumentation
Hour Meter
Refer to Figure 2-2 on page 12:
The hour meter registers 1/10 hour increments up to
9,999.9 total hours. The meter is connected to the ignition
switch and records accumulative time only while the
engine is running.
A plastic film covers the hour meter window. It protects
the window from scratches during shop assembly and
shipping. This covering should be removed by the owner
before placing mower into service.
Park Brake
Refer to Figure 2-3 & Figure 2-4:
The park brake lever is linked to the wheel motors. The
rear wheels are kept from turning when the lever is pulled
back to (ON). Push lever forward to (OFF) to release park
brakes.
Mower engine will stop running if park brake lever is set to
(ON) before spreading both control levers (OUT) or if one
or both control levers are moved (IN) before moving park
brake lever to (OFF).
Control Levers
Refer to Figure 2-3 & Figure 2-4:
The control levers are used to steer, accelerate,
decelerate, stop, and change direction of travel.
Always move both control levers to neutral and (OUT)
before setting park brake to (ON). Always leave park
brake and control levers in this position until ready to start
traveling. Move park brake to (OFF) before pulling control
levers (IN). Start moving by moving control levers either
forward or rearward from neutral position.
See "Driving the Mower" on page 16 for a detailed
description of operating the control levers.
12/15/15
Table of Contents
Both Control Levers Must Be Spread Fully (OUT)
Control Levers Fully OUT (in Park Position)
Control Levers Fully IN (In Neutral Position)
Before Park Brake Is Engaged (ON).
Figure 2-3
Control Levers (IN)
Neutral Operating Position
Figure 2-4
ZST40 & ZST48 Zero Turn Mowers 357-505M
Park Brake (ON)
33168
Park Brake (OFF)
Neutral Slot
33179
13
Advertisement
Table of Contents
