Attaching The Front Cover; Specifications - Yamaha NS-F700 Owner's Manual

ATTACHING THE FRONT
COVER
The speaker and the front cover are packed separately. To attach
the front cover, line up the projections (magnets) on the reverse
side of the front cover with their corresponding screw heads on the
speaker.
Notes
• When removing the cover, be careful that you don't touch
the drive units, and don't exert excessive force with any
tools.
• There are magnets on the reverse side of the front cover. Do
not place the front cover close to objects that might be
affected by magnets, such as CRT TV, clock, magnetic card,
diskette, etc., after removing it.
4
En

SPECIFICATIONS

Type .........................................3-way bass reflex speaker system
Driver .............................................16 cm (6.5") cone woofer × 1
Impedance ............................................................................... 6 Ω
Frequency Response ............................ 45 Hz to 50 kHz (-10 dB)
Nominal Input Power........................................................... 40 W
Maximum Input Power ...................................................... 160 W
Sensitivity ........................................................... 89 dB/2.83 V/m
Crossover Frequency ..............................................700 Hz/4 kHz
Dimensions (with stands)(W × H × D)
.. 354 × 1012 × 374 mm (13-15/16" × 39-13/16" × 14-3/4")
Weight........................................................... 25 kg (55 lbs. 2 oz.)
• Specifications subject to change without notice due to product
improvements.
• Care should be taken not to exceed the input power values noted
above.
• A speaker cable is not included with this model.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents (e.g.,
alcohol or thinners, etc.): this might damage the finish. Use
a clean, dry cloth. For difficult soils, dampen a soft cloth in
detergent diluted with water, wring it out, and then wipe with
the cloth.
Non-Magnetic shielding type
Advanced PMD
13 cm (5") cone mid-range × 1
Advanced PMD
3 cm (1") aluminum dome tweeter
DC diaphragm