King Canada KPW-3001FM Instruction Manual page 5

WARNING! Before turning on your pressure washer engine, you MUST check oil level, fuel level and air cleaner filter.
ASSEMBLY
Remove all the contents from the carton and proceed to the following assembly instructions;
Top handle
Install the top handle (A) Fig.1 to the lower frame (B). Position the top handle flat onto the
lower frame, insert carriage bolts (C) through both the handle and frame. Screw lock knobs
(D) but do not tighten.
Rotate top handle upright and push the top handle towards the lower frame. Tighten lock
knobs (D).
Hose hook and wand holster
Slide the hose hook (A) Fig.2 into the slot at the rear of the panel (B). Slide the wand
holster (C) into the slot on the side of the panel (B).
Wheels
Install the wheels to the frame by first pressing its spring loaded pin, then insert wheel shaft
into frame and align spring loaded pin with hole in frame until the pin snaps. Repeat for the
other wheel.
Wand and hose
Assemble the 2 piece stainless steel wand (A) Fig.3. Lower the rubber piece (B) to expose
the threaded fitting and screw the 2 pieces together, reposition the rubber piece. It is
recommended to install Teflon tape on the threads to prevent water leakage.
Next install the hose (A) Fig.4 to the wand (B) and install the other end of the hose (C) to
the pump outlet (D) as shown. It is recommended to install Teflon tape on the threads to
prevent water leakage.
Quick connect coupling
Install the quick connect coupling (E) Fig.4 to the water hose inlet (F). It is recommended to
install Teflon tape on the threads of the hose inlet to prevent water leakage.
ASSEMBLY
Figure 1
Figure 2
Figure 3
Figure 4