General; Installation Site Selection; How To Install The On-Off Controller - Toshiba TCB-CC163TLE Installation Manual

CAUTION
4

1. General

This booklet briefly outlines where and how to install the ON-OFF controller.
Please read over the entire set of instructions for the indoor and outdoor units
and make sure all accessory parts listed are with the controller before
beginning.
Give these instructions to the customer after finishing the installation.
NOTE
Part Name
ON-OFF controller
Tapping screw
Rawl plug
Manual
Switch name Label

2. Installation site selection

• Install the ON-OFF controller at a height of between 1 and 1,5 meters above
the floor.
• Do not install the ON-OFF controller in a place where it will be exposed to
direct sunlight or near a window or other place where it will be exposed to
the outside air.
• Be sure to install the ON-OFF controller vertically, such as on a wall.

3. How to install the ON-OFF controller

• Do not twist the control wiring together with the power wiring or run
it through the same metal conduit, because this may cause a
malfunction.
• Install the ON-OFF controller away from sources of electrical noise.
• Install a noise filter or take other appropriate action if electrical
noise affects the power supply circuit of the unit.
Do not supply power to the unit or try to operate it until the tubing and
wiring to the outdoor unit is completed.
Figure Q'ty
1
Truss-head
Phillips
For securing the ON-OFF
4 × 16 mm
4
controller
For securing the ON-OFF
4
controller
1 For installation
1 For operation
1
Remarks
OI-744-04EG