Speaker Installation - Pioneer DXT-1469UB Owner's Manual

Installation
DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracket and the side
of the unit match.
2 Tighten two screws on each side.
3
1
2
1 Truss screw (5 mm × 8 mm)
2 Mounting bracket
3 Dashboard or console
Removing the unit
1 Remove the trim ring.
1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-
cess to the trim ring.
! When reattaching the trim ring, point the
side with the notched tab down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
Press the detach button and push the front
panel upward and pull it toward you.
For details, refer to Removing the front panel to
protect your unit from theft and Re-attaching the
front panel on page 4.

Speaker installation

TS-165P
D
E
A A
F
G H I
B C
Front
A 45°
B f 4.3 mm holes (3/16 in. Dia.)
C f 142 mm (5-5/8 in. Dia.)
D 123 mm (4-7/8 in.)
E 113 mm (4-1/2 in.)
F 100 mm (3-7/8 in.)
G 123 mm (4-7/8 in.)
H 100 mm (3-7/8 in.)
I 113 mm (4-1/2 in.)
Installation
A B
C D E F
G
Side
A 13 mm (1/2 in.)
B 41 mm (1-5/8 in.)
C f 65 mm (2-5/8 in. Dia.)
D f 128 mm (5 in. Dia.)
E f 158 mm (6-1/4 in. Dia.)
F f 170 mm (6-3/4 in. Dia.)
G 27 mm (1 in.)
1 Determine the location of the speaker as
illustrated.
2 Make holes as illustrated. (If needed, re-
move the door upholstery.)
1
2
1 f 4.3 mm (3/16 in. Dia.)
2 f 128 mm (5 in. Dia.)
3 Install the speakers as illustrated.
1
3
2
1
2
1 Speed nut
Section
03
9
En