Denon AVR-1705 Operating Instructions Manual page 22

ENGLISH
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as (described) below.
1
Select the speaker whose level you want to
adjust.
(Remote control unit)
2
The channel switches as shown below each
time the button is pressed.
(Remote control unit)
FL CNTR FR SR
SW SL
NOTE:
• Please make sure the "AUDIO" position of
the slide switch on the remote control unit.
3
Adjust the level of the selected speaker.
(Remote control unit)
Default setting of channel level is 0 dB.
The level of the selected speaker can be
adjusted within the range of +12 to –12 dB
using cursor buttons.
SW channel level can be turned off by
decreasing one step from –12 dB.
OFF ´ –12 dB ´ 12 dB
22
3
1, 2
SB
II
Dolby Pro Logic
To play in the PL II x mode, set "S. BACK" at the Speaker Configuration setting to "SMALL" or "LARGE".
1
Select the function to which the component you
want to play is connected.
Example: DVD
(Main unit)
2
Select the STANDARD (Dolby Pro Logic
mode.
3
(Main unit)
• The Dolby Pro Logic
Display
3
Play a program source with the
mark.
• For operating instructions, refer to the manuals
of the respective components.
4
Select the surround parameter mode.
(Main unit) (Remote control unit)
To perform this operation from the remote
control unit, check that the mode selector
switch is set to "AUDIO".
II)
x (Pro Logic mode
1
(Remote control unit)
II
x)
2
1
(Remote control unit)
II
indicator lights.
Light
8
5, 7
Display
2 4, 6 5, 7
The Dolby Surround Pro
Logic II x Cinema or Music
mode can be chosen
directly by pressing the
CINEMA or MUSIC button
on the remote control unit
during playback in the
Dolby Surround Pro Logic
II
x mode.
4, 6
5, 7