Compal HEL80 User Manual page 111

User Password Is / Supervisor Password Is
These two fields shows that User /Supervisor Passwords are set or not.
Set
Clear
Set Supervisor Password / Set User Password
Enter this field always shows the message.
While this field is highlighted, press "Enter". The following message is shown:
If there is an old password then setup will prompt with the following window instead and a
current password will be required to be entered at first:
User can type password in field of "Enter New Password", and re-enter password in field of
"Confirm New Password " for verification.
If verification OK:
The supervisor password is set complete after user press "Enter".
If verification fails:
If password on boot is required, the password must be set otherwise it cannot be enabled.
The formats of the password are as follows:
Length: No more than 8 characters.
Characters: Alphanumeric keys only. The shift status, Ctrl, Shift, Alt, and Capital, are
ignored.
System Password is set.
System Password is not set.
Set Supervisor Password
Enter New Password
Confirm New Password
Set Supervisor Password
Enter Current Password
Enter New Password
Confirm New Password
Setup Notice
Changes have been saved.
[Continue]
Setup Warning
Passwords do not match.
Re-enter Password.
[Continue]
6 The BIOS Setup Program
[ ]
[ ]
[ ]
[ ]
[ ]
6-9