Table of Contents
Advertisement
DC Application
The DC output terminals may ONLY be used for charging 12 volt
automotive type batteries.
1.
Connect the positive ( ) battery cable to the generator positive ( )
terminal.
2.
Connect the other end of the positive ( ) battery cable to the battery
positive ( ) terminal.
＋
DC CIRCUIT
PROTECTOR
NEGATIVE TERMINAL
(BLACK)
3.
Connect the negative (
( ) terminal.
−
4.
Connect the other end of the negative ( ) battery cable to the
battery negative ( ) terminal.
5.
Start the engine (see page
To prevent the possibility of creating a spark near the battery,
connect charging cable first to the generator, then to the battery.
Disconnect cable first at the battery.
Before connecting charging cable to a battery that is installed in a
vehicle, disconnect the vehicles grounded battery cable. Reconnect
the vehicle's grounded battery cable after the charging cables are
removed. This procedure will prevent the possibility of a short
circuit and sparks if you make accidental contact between a battery
terminal and the vehicle's frame or body.
Do not attempt to start an automobile engine with the generator
still connected to the battery. The generator may be damaged.
Connect the positive battery terminal to the positive charging cord.
Do not reverse the charging cables, or serious damage to the
generator and/or battery may occur.
30
＋
−
) battery cable to the generator negative
−
15
).
＋
−
＋
POSITIVE TERMINAL
(RED)
Hide quick links:
Advertisement
Table of Contents
