Getting Started - EnGenius ERB9250 Quick Install Manual

Getting Started

1. Confirm that your Internet and the wireless network are active
before powering on your Range Extender.
2. Connect the two antennas to the antenna connectors on the rear
panel of your Range Extender.
3. Decide whether to use the Range Extender's Quick Manual
Configuration or WPS Configuration:
– Quick Manual configuration: It is highly recommended to use
this user friendly configuration method.
– WPS configuration: You can use this configuration method if
your router supports WPS.
4. After configuring the ERB9250 Range Extender with your router,
you can move ERB9250 to the place where a good signal (at least
3 bars) is still available and which is preferably in line of sight of
your router (as less barriers as possible). Please see "Placing
Your Range Extender in an Optimal Location" for how to find an
optimal location for ERB9250 Range Extender.
Quick Manual Configuration
1. Power on the ERB9250.
2. Disable any wireless connections present on the computer being
used to configure the Range Extender before setting up ERB9250.
Connect one end of the supplied Ethernet cable to the Ethernet/RJ45
connector on the rear panel of the Range Extender, and connect the
other end to an Ethernet port on your desktop or laptop.
3.
2
Thank you for choosing EnGenius.
Quick Install Guide