Residual Risks; Markings On Tool; Package Contents - DeWalt DWE1622 Original Instructions Manual

• Keep the magnet clean and free of debris and
swarf.
• Do not turn on the machine until it has been
mounted and installed according to these
instructions.
• Do not turn on the machine before having
checked that the magnetic stand has been
tightened firmly to the mounting surface.
• Adjust the table so cutter does not extend into
the workpiece before drilling. Do not perform
any design, assembly or construction activities
on the workpiece while the machine is turned
on.
• Before turning on the machine, make sure the
accessory has been mounted correctly.
• Always use the recommended speed for the
accessories and the material.
• Do not use the machine on the same workpiece
on which electric welders are being used.
• Use only an appropriate cutting fluid. Use a
general metal cutting coolant diluted with water.
• Do not use liquid cutting fluids while drilling
vertically or overhead. Dip the cutter in cutting
paste or apply an appropriate spray for these
applications.
• Do not pour cutting fluid into the reservoir
while it is mounted in the bracket. Do not allow
cutting fluid to enter the drill motor.
• Before use, ensure movable chuck guard
operates properly.
• Ensure that metal chips or resinous residue
cannot lead to blockage of the function.
• In case of jammed cutter disconnect the
machine from the power supply, remove
the reason for the jam before turning on the
machine again.

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury from flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.

Markings on Tool

The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
WARNING! This product is Class 1
Construction and must be connected to
an Earth connection.

Package Contents

The package contains:
1 Magnetic drill press
1 Drill guard
3 Handles
1 Hub
1 Safety chain
1 Lubrication system
1 Hex tool
1 3 jaw chuck with adaptor
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 5)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. On/off power/magnet switch
b. Off button for motor
c. On button for motor
d. Gear selector
e. Magnetic bracket
f. Feed handle
g. Hub
h. Tool holder
EN G LI SH
7